norstar 0X32 installation of T1 with analog trunk card

[OMARpr]

I HAVE A NORSTAR 0X32 RELEASE 6.1 AND I AM TRYING TO INSTALL A PRI AND AN ANALOG TRUNK CARD ON THE SAME KSU. HAS ANYBODY SEEN THIS CONFIGURATION AND IF SO CAN YOU PLEASE HELP ME OUT ON THIS. I'VE ALWAYS UNDERSTOOD THAT IT COULDN'T BE DONE.

 

[DTone]

there is no problem with that set up. but you have to put the T-1 card in slot 1 (all the way to the right) and the trunk card in slot 2. the program in Hardware. Also you need the PRI Keycodes. KDB

 

[BagsNYC]

No problems whatsoever. Use this config often without issue...

 

[janaya]

me too...should not be a problem.

true...put T1 in slot.

I think you need a services cartridge to power the T1. (please correct me if I'm wrong), but I put a T1 in a single cabinet and had to get the services cartridge to make it work.

If you add multiple cabinets and use the fiber card, make sure it's a fiber/combo card.

John

 

[salo0920]

I have used T1 / PRI in either or both slots 1 and 2 on the core. You do need the services cartridge or a 6 port combo card in order to provide timing for the T1 card no matter what slot its in.