Have a look to see if you're hardmon process is running on the cws. This seems to be the first thing checked on an spmon -d.
Do you get any output from the command or is just the one node acting up. Also, make sure the serials from the cws are connected to the nodes correctly.
Hardmon seems like running well 'cause all other Node's show Host respond = yes, but the 2 new ones don't. A refresh of Hardmon and other Subsystems like hats, hags and so on, didn't fix the Problem. Or do i have to refresh them in a especial order?
there is a host responds and a switch responds. if you have no host responds check to make sure all of your subsystems are running on your node. run `lssrc -a | grep ha` and then start them if they are not running by issuing `startsrc -g "subsystem"`.
If the SP Nodes have been added make absolutely sure that the adapter info is correct on the Control Workstation, as this could also be the problem, especially when booting via NIM
You need to check by running the following commands
On CWS
splstdata -a -l XXXXX node number (checks adapter info)
splstdata -n -l XXXXX node number (checks node info)
splstdata -b -l XXXXX node number (checks bootinfo)
Check /var/ha/log/hags. for any errors
Affected Nodes
Then goto the afected nodes and check if hags is running and also the errpt to see if the software is having problems. If software is OK you could run the command
syspar_ctrl -r (this refreshes the daemons) or
syspar_ctrl -D (this deleted the SP daemons) then
syspar_ctrl -A (this rebuilds the SP daemons)
One you have done this then go back to the CWS and refresh the daemons by runnings
After deleting and rebuilding the ha daemons on the nodes and refreshing them on the CWS all is running fine now. So refresh only didn't work... Thank you all guys...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.