Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

No dialtone on analog ports

Status
Not open for further replies.

srcvh1

Technical User
Feb 1, 2007
156
US
This seems like it may be as basic as a bad card but here goes: Installing a brand new CS1000. Programmed analog card in slot 4 0 6. I have DTRs programmed on 4 0 15 but no dial tone. Am I missing something? Maybe something that needs to be turned on in CDB, HELP?
 
No Dial Tone on Analog phones.
Analog phones on large systems require a Digitone Receiver (DTR) card for dial tone.
Add a DTR card to a Peripheral Shelf, and program it in LD 13:

REG NEW
TYPE DTR
TN l s c u You must do this 8 times, to add Tone channels 0 thru 7.

Print DTR in LD 20.
STAT in LD 32.

 
On the CS1000 1010 Cabinet the DTR is virtual. I have the DTR programmed on card 4 0 15. By the way, I just found out there is no dialtone on the 3900s either. I am clearly missing something here
 
Like this

MGTDS IPMG IPMG_TYPE
124 000 0 MGC
126 000 1 MGC
128 004 0 MGC
130 004 1 MGC
132 024 0 MGC
MGCONF IPMG PORTS IPMG_TYPE
125 000 0 30 MGC
127 000 1 30 MGC
129 004 0 30 MGC
131 004 1 30 MGC
133 024 0 30 MGC
 
Just chg the MGTDS and MGCONF and still have the issue. Is there something else I'm missing?

CEQU
SUPL V004 N096 V100 V104
SUPC
SUPF
XCT 000 016
CONF *001 *017
MGTDS IPMG IPMG_TYPE
128 004 0 MGC
MGCONF IPMG PORTS IPMG_TYPE
129 004 0 30 MGC
IPCONF NODE
IPTONE NODE
 
By the way, is 128 and 129 standard TDS/CONF for all CS1000s?
 
I don't think there is a standard. You should also make sure you have your DSP's programmed as well as registering the MGC card into the security domain.
 
KCFLHRC, I did check the DSPs and they were idle and registered. I finally got to a point with this that I just reset the MGC card and re enabled. After re registering everything came up fine and I had my dial tone. Thing just needed a kick in the ass! Thanks for all your help
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top