livers1968
Technical User
I have DPNSS links between Nortel CS1k rlse 5.0 and Siemens ISDX. All other system features work but the name is not sent across the link to or from the CS1k.
Can anyone help on this?
Can anyone help on this?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
No CPND across DPNSS 1
- Thread starter livers1968
- Start date
- Status
captaingadget
IS-IT--Management
I believe CPND is a Nortel specific protocol and is not understood by other systems.
-
1
- Thread starter
- #3
livers1968
Technical User
Well I have seen it work between Nortel CS1k and other systems over DPNSS links, and according to the NTPs it should work.
Not over DPNSS - You will only see LocationCode and Extn Numbers and certain levels of features, not all of them, when networking between different PABX's (Comman Channel Signalling) for all your 'B'Channels unfortunately no Nortel proprierty signalling over the Commmon '16'
Interesting to see your comments were you've seen it working, are you sure it was DPNSS?
Cheers!!
Interesting to see your comments were you've seen it working, are you sure it was DPNSS?
Cheers!!
- Thread starter
- #5
livers1968
Technical User
Well according to the NTP it can work on DPNSS1 links but the dialling plan has to be UDP.
Has anyone ever implemented thus?
Has anyone ever implemented thus?
911guru
Programmer
- Nov 10, 2007
- 437
What's the RCAP on your DCH look like? Have you enabled DCH tracing to see if it;s being sent?
911Guru
E911 FAQs are located at:
911Guru
E911 FAQs are located at:
- Thread starter
- #7
livers1968
Technical User
DCH or DCHI is not used. There are RDC and VDC programmed as the DPNSS channels.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
