No card installed at requested slot (dual framer)

[jrgood0852]

Has anyone seen when programming a new link the programming takes, but when you do STATE cmd. the above (subject) is encountered? Thanks.

 

[Waldosworld]

model of 3300? dual framer not supported by CX's
in controller module config form, what card is programmed as installed vs what the system generated portion?
if no card shown in system generated, reseat card.

 

[jrgood0852]

Thanks, man. It is an MXE2 and I swapped the dual framer already, so not the card.

 

[Waldosworld]

Have seen MMC slots be finicky and even faulty, try spare slot if available.

 

[jrgood0852]

Thank you. I have a ticket with Mitel and waiting for their suggestions, too. Appreciate it.

 

[augustD2]

I already had this problem and if I remember correctly it was because I forgot to program the ISDN Protocol form.

 

[LoopyLou]

Have the spare digital link licenses?

I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.

 

[jrgood0852]

Thanks, p011406. That was it!