Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

No add command

Status
Not open for further replies.

evoguy

IS-IT--Management
Mar 31, 2007
52
BB
I have just installed CM 5.2.1 on an S8300/G700 acting as the main server. however i do not have the "add" command. i have issued a couple reset system 4 however i still do not have it. what can be the cause of this...can it be the license file?
 
ok reset sys 4 finally worked :)
 
yes, on initial setup, you need to do a "save trans", then a "reset system 4", before ANY change/add or most commands are available :)

Mitch


Mitch

AVAYA Certified Expert
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top