Nexus 7000 - no switchport command does not work

[m4rc00]

Hi,

I need to configure one port on Module 1 and met some issue

XXX(config-if)# no switchport
ERROR: Ethernet1/30: requested config change not allowed

Below modules which are in this Nexus :

XXX(config-if)# show module
Mod Ports Module-Type Model Status
--- ----- ----------------------------------- ------------------ ----------
1 32 1/10 Gbps Ethernet Module N7K-F132XP-15 ok
5 0 Supervisor module-1X N7K-SUP1 active *
10 48 10/100/1000 Mbps Ethernet XL Module N7K-M148GT-11L ok

Port is down (nothing connected), SFP is inserted.
When i tried to do the same operation on Module 10 (the same situation with port ) there was possible, here is not

Have not found anything on the google, have anyone this in your network ?

 

[imbadatthis]

F1 series are L2 only ...

if you need to route for some reasons, use an SVI ...


int e1/30
swi ac vlan 10



int vlan 10
ip address 10.10.10.1/24


there now.. you have routing..... you got an M1 series card.. you should be able to route.

We must go always forward, not backward
always up, not down and always twirling twirling towards infinity.

 

[m4rc00]

imbadatthis - thanks, it works pretty well