Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Newbie ?

Status
Not open for further replies.

TampaTech

MIS
Dec 9, 2002
4
US
I'm new to the PIX world and have inherited a 515...I need to allow two IP addresses from the outside (on different networks) into my network to connect to only one machine....(10.20.30.11) how is this done?
 
First of all give the internal ip a static entry to a registered address (assuming you have one to spare)

Then create an access-list allowing those specific hosts to that static address.

example:

static (inside, outside) <registered ip> <internal ip>

access-list inbound permit ip host <remote 1> host <registered ip>
access-list inbound permit ip host <remote 2> host <registered ip>

I hope this helps

Dave
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top