Newbie having dumb problems within a CHG request...

[cr8z3d]

Hi there all,

I'm a Desktop tech who recently inherited the responsibility of managing our Meridian PBX phone system and after receiving only 3 hours of "wonderfully intensive" training i'm hung up one little problem. Essentially, I'm creating new accounts by way of cpy 1 and then i dump that into a free DN (x1000) we use for that function. When I go to modify that copied account, i'm having problems changing the display name on the account. I'm just not sure on the syntax, and I was hoping one of you can give me a hand.

This is as far as I get...

<I do a>
REQ: CHG
TYPE: 2616
TN 12 0 7 11
ECHG YES
ITEM KEY 0 SCR 1000 <...this is where I get screwed up, not sure what syntax to use to display the name>

Sorry to bug you all with such a pathetic request, but if you can help me out it'll be most appreciated.

thanks!

 

[one234]

Hi,

What is the SCH code you recieve?

Marc D.

No trees were killed in the sending of this message. However a large number of electrons were terribly inconvenienced.

 

[cmawbey]

change the name in LD95

Colin

 

[phonedude10]

AFTER DN YOU SHOULD GET MARP HIT RETURN AND GET CPND ENTER
NEW OR CHG RETURN ENTER NAME.

 

[cr8z3d]

Thanks phonedude10...that did it. Whoo hoo...I can finally be productive. Thank you all for your feedback.

I think i'll check out LD95, see what that's all about.

=)