How do I setup a new user with a meridian 2616 phone via terminal (ld ?). I am using an established system for the first time, so any help would be appreciated.
might help to read a few older post.. they was some pretty good faq's on that at one time... here's a short jump start..
after you print a simular set.. you need two things, a tn and a dn...
ld 20
prt
luvu
2000 (that finds all vacant terminial numbers for digital sets)
return, and copy one tn from that list
then (still in 20)
prt
ludn
0
x that is the leading number your looking for.. if most stations in that dept is 5, i usually look for a 5, a return with no 1st digit gives you all vacant dn's..
once you get those two, follows scotts lead..
ld 11
cpy
2616
4 0
5 0
507
that would make a copy of the 2616 on tn 4 0, the new tn, 5 0.. key 0 will be ext 500... those are normal tn's for an opt 11.. (on the wall switch) for larger systems the tn format is 4 0 0 0 for the 1st pair on that cable (cable 5)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.