New to Hicom

[spanton]

Is there a command that would printout what is programmed within the switch? (i.e. Total analog set, digital set..etc)

 

[sbcsu]

You can try
DISPLAY-CODEW;
That will show how many licences have been used.
Depends on the version and what your experience level and access level are.

 

[donb01]

Look in the "Used" column under DIS-DIMSU; That will show you the total of many different objects that are currently in use, the maximum of that object that have been in use, and the maximum the system is configured to allow of each object. The CODEW is good as sbcsu stated, because it tells you the max licenses you have in the system and how many you are currently using, which will show you how much your system could conceivably grow. If DIMSU says the maximum number of stations you can have on the system is 100 then it will not matter how many licenses you have or how many open hardware ports (with the possible exception of Analog - I'm not sure if they care about those anymore!) - it will not allow you to add another phone (until after you edit that limit a little).


Don Bruechert, Voice Comm Analyst II
CareTech Solutions @ Holy Family Memorial
Manitowoc, WI, USA