New scope in DHCP server 1

[juruk]

I just install DHCP server in my test area and I am setting new scope which is in other range that the 2003 server itself. When I connect new pc I am getting message that the dhcp server is unavailable. If I set scope within the same range as the server itself everything works fine. Am I doing something wrong or I need to set some other setting that I am not aware of it. ?!
To be more specific this is what I have.

W2k3 server ip: 192.168.0.100
SM 255.255.255.0
DG 192.168.0.1
Preferred DNS 192.168.0.100

My new testing scope 192.168.1.1-192.168.1.100 error DHCP not available

When I set the scope to 192.168.0.1-192.168.0.100 everything works fine

No routers at all since this is testing LAN.

Any help appreciated.

Thank you
Juruk

 

[markdmac]

Did you authorize the DHCP server? Did you activate the scope?

I hope you find this post helpful.

Regards,

Mark

 

[juruk]

Yes i did authorize the server and i also activate the scope. It is working on the same scope with the server but changing the sope ...dhcp is unavailable.

 

[markdmac]

Looks to me like you need to add 192.168.1.100 as a static addess to your server. You have it issuing IPs to a subnet it does not belong to.

I hope you find this post helpful.

Regards,

Mark

 

[juruk]

I understand that, but I was thinking that you can create a scope which is different than the server itself and provide ip’s with in different range. Therefore my conclusion is that I can’t use different scope…. correct?
Juruk

 

[markdmac]

Not to my knowledge unless you are doing reservations.

I hope you find this post helpful.

Regards,

Mark

 

[juruk]

Thank you very much markdmac i really appreciate your help
Juruk