New PRI for Opt 11...looking for quick cheat sheet

[joed1228]

I have to program a new PRI T1, the customer wants more trunks in an exsisting route.

I am looking for brief details, something to let me know in specific order which loads to go into and the function of each load. Something such as:

1.) Load xx to program the loop
2.) Load xx to program the d-chan
3.) Load xx to add the PRI to exsisting route
4.) Load xx to program the trunks

Which loads do I go in by order and what function is set up in each load.

 

[phonz1]

LD 17 to program the loop (DLOP)
LD 17 to program the d channel (ADAN)
LD 14 to program the trunks.

The new trunks will be added to the existing route, prt an LTM in LD 21, find your route and the last member, then when you add the new trunks, under the RTMB prompt insert your route and the starting member for the new trunks

 

[EddieDuece]

1.Print the CEQU in ld 22
2.Declare the t1 in CEQU LD 17.
3.Build the D-channel in ADAN LD 17
4.Build the Route in LD 16
5.Build the Channels in LD 14
LD 14
REQ new 23

you can build all the channels at once by typing:
"NEW 23"

 

[johnpoole]

are you adding a dch as well? ld 22 prt to find a vacant dch or the next vacant device number.. if this is a new card set the switches to reflect the device number.. then add the d in 17, in 96 enl msdl x fdl to write that to the card... then when you add the loop and isdn yes you can ref that dch... after the build ld 60 enll x to bring it up, the d should estblish within 2 minutes... if not bring the t back down, ld 96 enl serv x

john poole
bellsouth business
columbia,sc

 

[joed1228]

Yes, I will have to add a DCH.

 

[hawks]

Try these

http://www142.nortelnetworks.com/techdocs/M1242x_NA/pdf/NSM5S9GQ.pdf

http://www142.nortelnetworks.com/techdocs/M1OPT1125_40/pdf/NR4_1_RV.pdf

 

[joed1228]

How do I print an exsisting DCH's settings?

How do I find the spare DCH numbers? In LD 22 I can print the ADAN and I see 10, 11 and 12 in use, do I just pick 13 because it isnt used?

 

[bigindian65]

ld 22
prt
adan dch <enter>


Mato' Was'aka

 

[phonz1]

you can only use an unused adan number for a dch, prt your adans and pick one that's not used between 0 and 15, if 13 isny used for anything else, then you can use it