New 250W PS
New Intel 815EPEA2 Mobo
New Case
Used 2-128 Mg Ram
used 667 Cel CPU & Fan
Used 3 1/2 floppy
New 20Gig MAxtor HHD
New Polaroid 24X CE-RW
Used 15" monitor
Used Voodoo3 2000 vid card
New Mouse
New Keyboard
All used work.
Only question is CPU came out of machine hit by lightning,
and computer techs said mobo was bad.
My question is problably answered by my last sentence but I would like to be sure before I spend more money on a processor since I have no way of testing this one. This is a test build before I start the more expensive on so i don't what to get a lot stuck in it. That is one of the reason I bought this cheap board is to match the CPU. Yah, I know, one that was in a system hit by lightng.
Christmas tree lights don't go all the way to the top.
OK enough bashing myself:
Computer turns on, CPU fan runs, case fan runs, green light on board is on, light for HHD, floppy, power are on.
Monitor shows check signal cable.
The front power switch is doesn't shut the computer off or turn it on for that matter. Check connects and they appear to be in the right places.
The computer does not beep when turned on. I have speakers plug into the back audio. The front speaker with the case has no where to jumper on the main board. I unsure of how to jumper to a peripheral power conn(i don't know if a speaker is 5V or not) and if it is the right way to do it.
I have disconnected the floppies, and HHD, CD-RW and still acts the same.
I have tried the vid card in 2 different slots and no difference.
CPU the culprit? "Patience is but a waste of time"
New Intel 815EPEA2 Mobo
New Case
Used 2-128 Mg Ram
used 667 Cel CPU & Fan
Used 3 1/2 floppy
New 20Gig MAxtor HHD
New Polaroid 24X CE-RW
Used 15" monitor
Used Voodoo3 2000 vid card
New Mouse
New Keyboard
All used work.
Only question is CPU came out of machine hit by lightning,
and computer techs said mobo was bad.
My question is problably answered by my last sentence but I would like to be sure before I spend more money on a processor since I have no way of testing this one. This is a test build before I start the more expensive on so i don't what to get a lot stuck in it. That is one of the reason I bought this cheap board is to match the CPU. Yah, I know, one that was in a system hit by lightng.
Christmas tree lights don't go all the way to the top.
OK enough bashing myself:
Computer turns on, CPU fan runs, case fan runs, green light on board is on, light for HHD, floppy, power are on.
Monitor shows check signal cable.
The front power switch is doesn't shut the computer off or turn it on for that matter. Check connects and they appear to be in the right places.
The computer does not beep when turned on. I have speakers plug into the back audio. The front speaker with the case has no where to jumper on the main board. I unsure of how to jumper to a peripheral power conn(i don't know if a speaker is 5V or not) and if it is the right way to do it.
I have disconnected the floppies, and HHD, CD-RW and still acts the same.
I have tried the vid card in 2 different slots and no difference.
CPU the culprit? "Patience is but a waste of time"