New install IPO500 PCS>14, recreated SD card using Manager 9.1.2.0 build 91, copied offline config.cfg to System/Primary folder, insert SD, power up, manager discovers IPO (also can ping IPO from Manager pc), but using default Admin login and password fails. Any suggestions? Thx
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
New IPO500 install, v9.1, default Admin password login fails
- Thread starter jjjohn
- Start date
Firebird Scrambler
Systems Engineer
It might be best if you post your thread on the IP Office forum at
However, as you have a backup config copy, I think there is a way to read the password from the file as it might have changed.
I was told that a tool called "Snadboy's SetupRevelationV2.exe" was used. I've seen it being used as all you do is browse over the password area to reveal the password used in the config file.
Firebird Scrambler
Nortel Meridian 1 / Succession and BCM / Norstar Programmer in the UK
Advance knowledge on BCM support
However, as you have a backup config copy, I think there is a way to read the password from the file as it might have changed.
I was told that a tool called "Snadboy's SetupRevelationV2.exe" was used. I've seen it being used as all you do is browse over the password area to reveal the password used in the config file.
Firebird Scrambler
Nortel Meridian 1 / Succession and BCM / Norstar Programmer in the UK
Advance knowledge on BCM support
The Password on an IPO is stored internally, not in the config. If you are unable to access it then you will likely need to do a security reset through the Serial port on the back.
Then the default credentials should work.
Then the default credentials should work.
- Status
Similar threads
- Locked
- Question
- Question