New Installation = IP Phone 2004 shows Unequipped

[msobkowi]

I'm in the process of installing a CS1000S. I have finally been able to get all the components working insync. I'm more familiar with BCM's and not the CS1000 product line. Anywys, I am trying to get phones to register on the system. Whem the phone boots up, it prompts for a Node and TN
I enter Node =1 since I only have one Node and that is its Id.
For the TN I entered 61-00.
After the phone does its firmware upgrade, message on the phone says
Invalid TN:61-00
Reason:Unequipped.

What have I forgotten to do? or what is missing from my equation.
Thanks
Mathew

 

[msobkowi]

Thanks guys. I actually have 2 way calling now. I'm very excited right now. Its been 3 days now trying to learn and configure this stupid ancient system. Now just have to figure out what else I can do with the system now.
Where can i read about the different type of keys I can assign. Is there somewhere where it shows which keys are which mapped to the actual phone.

 

[gwebster]

I assume that you have the NTPs if you are installing a sytem. Start with them.

 

[msobkowi]

I have access to all the NTPs, but not sure which one would have the information I am looking for.

Mathew