Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

New Install-NPR327 when trying to enable superloop 28

Status
Not open for further replies.

kce9751

Programmer
Nov 18, 2008
59
US
Hello,

I am working on a new install. I have 2 IPE shelves. One IPE shelve is split between two different superloops.(8-1 and 28-0..2 segments each). The other IPE shelve is 28-1 with 4 segments. I am unable to enable superloop 28 with the enll command or enls, I receive NPR327. I've swapped the superloop card with another and get the same message. I've checked the cabling as well. The 8-1 part of the shelf works fine and the lights went off but superloop 28 will not come up. Any ideas? Thanks. See below for the configuration.

enll 28

NPR327
.stat 28
SUPER LOOP
DSBL RESPONDING
.enll 28

NPR327




REQ prt
TYPE supl
SUPL

SUPL SUPT SLOT XPEC0 XPEC1 SHLF ZONE0/1 IPR0/1

008 STD RGHT 02 0 3 03 0 1 --- --- - --- ---------------
012 STD LEFT 01 0 3 -- - - --- --- - --- ---------------
028 STD LEFT 03 2 3 04 0 3 --- --- - --- ---------------



>ld 97
SCSYS000
MEM AVAIL: (U/P): 45317043 USED U P: 6240552 55074 TOT: 51612669
DISK SPACE NEEDED: 65 KBYTES
REQ prt
TYPE xpe
XPEC

S0 S1 S2 S3 LOC DIS RGTP

01 012 012 012 012 C00M1 NO 08
02 008 008 008 008 C00M2 NO 16
03 008 008 028 028 C00M3 NO 16
04 028 028 028 028 C01M1 YES 16
 
have you done a ENXP 3 or ENXP 4 in LD 32 to enalbe the controller?
 
Yes, I've done that and the controller does not come up because the loop is disabled.
 
what slot do you have the nt8d04 plugged in? the right or left slot of loop 28, should be left side according to how you programmed it. you are aware that the bottom connector on the faceplate is xpec 3 and the top connector is xpec 4. on the ipe shelf that is xpec 3 the cable should be plugged into connector s2. on the ipe shelf that is xpec 4 the cable should be plugged into s0.

if the cables are not plugged in securely on the faceplate connectors of the nt8d04 you will have problems. you didn't say that you had frogged the controller cards as well. You should do that. Before unpluging the controller cards you should remove power from shelf.
 
Thanks wane. That's definitely worth a try. I'll frog the controller cards.
 
why do you have 28 0 and 28 1 built on your xpe side and only ? 28 0 is plug j1, 28 1 is plug j0 on the network card..


i would remove the extra xpe, enls the shelf..

john poole
bellsouth business
columbia,sc
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top