Networking

[eperez923]

I have an Option 11c on one end and on the other end I have a Telrad 400 PBX. Anyways, these two are connecting through a frame line. Is there a way I can see the configurations on Notel switch on how they are connecting to each other. The configuration was done about 5 years ago, and I had assistance when doing this but lost communications with this person.
Does anyone have something set up like this?

 

[eperez923]

Great!
I was able to see everything on ld21 and I was able to see the card on ld60.
There was one other thing that I remember when this was set up. He mentioned setting it up under qsig. I did not see anything in ld 21 about qsig. Any idea where else I may be able to check this?

Thanks a lot I appreciate all the help.

 

[djwht]

LD 22
req = prt
type = adan dch x (enter the dch number of that loop)
press enter for everything else

look at the IFC prompt is should say esgf or isgf you can see the same info in the rdb printout in LD21...the route IFC prompt is the same as the DCH IFC prompt.