Networking Octel OV250

[rod1248]

I am about to start a networking project that will entail networking 4 OV250 Octels and 1 Modular Messaging system using a Message Networking Server. The customer would like the Message networking server to handle all network calls with out a node (they want to be able to dial 4 digits to network to anyone one the campus). My question is, is there a way to set up the octels to automatically route the calls through the MN server regardless of where they are sending the message without the use of a node number? Or is the only way to accomplish this by creating the same node on all the octels that would send the call to the Message networking server and let that machine figure out where the calls need to go? Any thoughts?

Ray...

 

[ChuckRCT]

Are you sure that mailboxes on the Miner and Facilities systems don't conflict with entries already in the S3210?

 

[rod1248]

Yes, we made sure of that before we started to try and network them. We pulled a user list from all of the systems to verify.

 

[KenMeans]

What is the software level of the Octel? And i hate to ask but can you post a screen shot of the node from the S3210?

Ken Means

http://www.tel-is.com

 

[KenMeans]

Also is there anything that is working ? can you send a message or does that also fail?

Ken Means

http://www.tel-is.com

 

[rod1248]

The octels are at 3.11 sw release. Since we are trying to route everything through the 3210 none of it is working.
I was trying to post a screen shot of the nodes on the 3210 but I it will not let me for some reason.

I will e-mail it to you.

Sorry for the delay in response.
Ray

 

[KenMeans]

if you still have my number call me

Ken Means

http://www.tel-is.com