Network service in QSIG 1

[antek]

How to set the ISDN route to enable network service.How must be seting the parameters in VARI,VARO,VARC?If You can give me advices step by step how to run network service in QSIG.

 

[TRIDENT100]

A SITE:

ROU=XX
SEL=511000000000001
TRM=4
SERV=3010030000
TRAF=03151515
SIG=111110000031
BCAP=111111
NODG=0
DIST=30
DISL=128

VARC=00000310
VARI=05400000
VARO=06000000

ADC=064610000000008000600000
***************************************


B SITE;

ROU=XX
SEL=511000000000001
TRM=4
SERV=3010030000
TRAF=03151515
SIG=111110000031
BCAP=111111
NODG=0
DIST=30
DISL=128

VARC=00000310
VARI=05400000
VARO=06300000

ADC=064610000000008000600000

 

[SYAR2003]

Note that !
Theese are ECMA Q-Sig parameters.

Note For BC11/12 only !
For ISO Q-Sig
Change the
VARI D1 to 7 .
VARI D4 to 4 (with General Protocol Updates)

VARI D1 set channel numbering as 1-30(7) values(4-7)

User-user tunneling through in generic function protocol.
VARI D1 = 7 ( Supp GFP,UUI in GFP,channeling 1-30 )


Making tie lines following ISO Q-Sig is mostly
recommended today .


/Syar.

 

[mdman]

Note:
Path Replacement doesn't work when tunneling UUI through GFP.

 

[SYAR2003]

mdman !
From where is this .. ?

"QSIG-Path Replacement in BC11 sp13"
Networking enhancements: Support for standard QSIG-Call Forwarding, QSIG-Call Transfer and QSIG-Path Replacement, and UUI transport in QSIG GF messages.

You have to include it in parnum 223 .