K, it's been a hellish night trying to upgrade a netware 3.12 servers hardware. New everything, drives, mainboard, nic etc.
The dimwit who loaded the server 8 years ago for sure didn't know what he was doing. Theres a boot partition on the SYS drive and another on VOL1. Found out the hard way that VOL1 is the boot drive. Grrr. The original VOL1 IDE drive died this morning and the original SCSI SYS drive is full of bad sectors. Ghosted the pair without too many problems.
Anyhow, i'm running 3 40 gig IDE drives now. Going to leave the SYS drive alone at 1 gig (scared to touch it at this point). I've created a VOL3 on a new hard drive but netware will only create an 8 gig partition, not the full 40.
Any ideas on what I can do here?
Thanks.
~ K.I.S.S - Don't make it any more complex than it has to be ~
The dimwit who loaded the server 8 years ago for sure didn't know what he was doing. Theres a boot partition on the SYS drive and another on VOL1. Found out the hard way that VOL1 is the boot drive. Grrr. The original VOL1 IDE drive died this morning and the original SCSI SYS drive is full of bad sectors. Ghosted the pair without too many problems.
Anyhow, i'm running 3 40 gig IDE drives now. Going to leave the SYS drive alone at 1 gig (scared to touch it at this point). I've created a VOL3 on a new hard drive but netware will only create an 8 gig partition, not the full 40.
Any ideas on what I can do here?
Thanks.
~ K.I.S.S - Don't make it any more complex than it has to be ~