I installed nw6sp4e (downloaded from the novell website) on two servers, which were at the sp3. After the install, I manually down the servers, at the c:\nwserver prompt type in server. As the servers came up, I noticed it still showed version 3. Also, when I typed in version at the system console, it still shows revision 3 March 27, 2003.
I tried a second install on both servers with the same results.
I am in process of comparing files from the backup4, they seemed to have been updated.
Any ideas as to why? -it is not showing revision 4 - December 12, 2003 - I do have a third server in the tree but this one was installed to the tree with service pack 4 already on it.
The servers are up and running. Although one server (secondary) has an issue with Apache (see TID10070605), and one server (master) had corrupt broker, which I replaced the psm files for ndpsm and that seemed to fix it.
Do I need to backed the server to service pack 3 and try the install again?
thanks
jane
I tried a second install on both servers with the same results.
I am in process of comparing files from the backup4, they seemed to have been updated.
Any ideas as to why? -it is not showing revision 4 - December 12, 2003 - I do have a third server in the tree but this one was installed to the tree with service pack 4 already on it.
The servers are up and running. Although one server (secondary) has an issue with Apache (see TID10070605), and one server (master) had corrupt broker, which I replaced the psm files for ndpsm and that seemed to fix it.
Do I need to backed the server to service pack 3 and try the install again?
thanks
jane