Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Netscreen RDP portmapping?

Status
Not open for further replies.
matthijsNL

matthijsNL

Technical User
Apr 24, 2006
43
0
0
NL
I'am a new user of a Netscreen firewall.

I've a good knowledge of Cisco PIX and Nokia Checkpoint.

I would like to map an inside TCP-port 192.168.20.1/RDP to a public address?

What is the easiest way to do this?
 
Sort by date Sort by votes
This is done with either a MIP or VIP. With a MIP it is possible to configure a 1 to 1 mapping so long as you have available public IPs to use for the public side. But if you only have a single public IP then you should configure a VIP to allow TCP ports 3389-3390. Check on the C&E guides for details on how to configure a MIP or VIP.

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

ciscokid1984
  • Locked
  • Question
Watchguard RDP from external network
Replies
1
Views
97
hairlessupportmonkey
hairlessupportmonkey
ISDPCMAN
  • Locked
  • Question
RDP fails over VPN
Replies
1
Views
66
gkittelson
gkittelson
ITSurvivor
  • Locked
  • Question
Newbie On Netscreen 25
Replies
0
Views
27
ITSurvivor
ITSurvivor
IBMX350
  • Locked
  • Question
Netscreen 50 Mapped IPs
Replies
0
Views
22
IBMX350
IBMX350
OldSkoolSkater
  • Locked
  • Question
RDP to TS gateway through company proxy using PAC file
Replies
0
Views
27
OldSkoolSkater
OldSkoolSkater

Part and Inventory Search

Sponsor

Back
Top