Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Netscreen RDP portmapping?

Status
Not open for further replies.

matthijsNL

Technical User
Apr 24, 2006
43
NL
I'am a new user of a Netscreen firewall.

I've a good knowledge of Cisco PIX and Nokia Checkpoint.

I would like to map an inside TCP-port 192.168.20.1/RDP to a public address?

What is the easiest way to do this?
 
This is done with either a MIP or VIP. With a MIP it is possible to configure a 1 to 1 mapping so long as you have available public IPs to use for the public side. But if you only have a single public IP then you should configure a VIP to allow TCP ports 3389-3390. Check on the C&E guides for details on how to configure a MIP or VIP.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top