I just received a Netra i server. I know very little about Sun products. Anyway my question is how do I configure the server from a PC. I checked Sun's web site and they say use the config disk that came with the server. Well I do not have that disk and could not find it to download on there web site. Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
netra i configuration help
- Thread starter jcon109
- Start date
To config a Netra from a pc you need a network cable to plug into the LOM port on the back of the Sun. The other end of this cable goes via an adaptor in to the serial port of your PC.
You then need to use hyperterm on the PC (9600,8 bits, no parity, 1 stop bit, Xon/Xoff) to talk to the Sun.
Steve
You then need to use hyperterm on the PC (9600,8 bits, no parity, 1 stop bit, Xon/Xoff) to talk to the Sun.
Steve
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question