netfinity 5600 Windows NT install - SCSI Adapter Driver Issue 2

[cmcdan1523]

I cannot install windows nt server r4.0 onto a netfinity 5600 server. I begin installation - press f6 when necessary and attempt to install the driver for the serveraid 4l adapter, but cannot find the correct driver. I have scoured the IBM site and even driverguide, but cannot find a driver that will allow the system to see the drives. Am I doing something wrong or is this a bug that others have run into? Am I missing something? Any suggestions or help on this one?
I also am looking for the latest version of serverguide for this server(6.1.3) to see if this will help things. If someone could place it on an FTP site somewhere. Help, I am ready to drop this box off the seventh floor.

 

[ibmtech65]

How did you create your drive array?

If you have a serveraid manager CD look in the books folder for the devdrv.pdf doc which will provided instructions on how to create the device driver.

You can get the lastest drivers here.

http://www-306.ibm.com/pc/support/site.wss/document.do?lndocid=MIGR-39723

Ray Liles
IBM/Intel Remote Technical Support Specialist
IBM Global Services
Atlanta Ga.

 

[cmcdan1523]

I used serveraid 5.0.5 to create the array and logical disk.
I also used serverguide to initiate the install of windows NT. I get to the point that I can press F6 and specify the mass storage controllers. I install both the 7800 series family driver and the serveraid 4l driver. As the installation continues, I am prompted once again to specify the mass storage devices. It accepts the 7800 series family scsi driver, but when I attempt to install the serveraid 4l driver again, it says that the device does not exist. At this point all I can do is continue and I immediately receive the message that there were no hard disks found.

The end of the install.....

 

[bilkel]

goodyrman, i also need 6.1.3 for use with an x342, have spoken to 2 rockstar techs in atlanta this evening and they tell me it is NLA---did you ever find an .iso of it or can i possibly get a copy from you?

 

[airborne18th1]

90p2778.iso 598,081,536 IBM ServeRAID CD Image

http://www-306.ibm.com/pc/support/site.wss/document.do?lndocid=MIGR-39723

use this link to create a boot cd, then setup your raid. then create driver disks from cd and load the driver by pressing f-6 when prompted.