Jul 21, 2020 #1 nthnu MIS Aug 26, 2013 41 US The info I'm needing to get is if our PBX has B8ZS/ESF and NI2. If I run LD 60 and stat I can get - FFMT/LCMT/YALMT: ESF/B8Z/FDL But I can't seem to figure out what to use to see if we have NI2. Is there a better way to get what I'm needing? Any ideas? Thanks
The info I'm needing to get is if our PBX has B8ZS/ESF and NI2. If I run LD 60 and stat I can get - FFMT/LCMT/YALMT: ESF/B8Z/FDL But I can't seem to figure out what to use to see if we have NI2. Is there a better way to get what I'm needing? Any ideas? Thanks
Jul 22, 2020 Thread starter #2 nthnu MIS Aug 26, 2013 41 US ld 22 REQ prt TYPE adan dch (then dch number from ld60) NI2 (look next to ifc) Upvote 0 Downvote
Jul 24, 2020 #3 bignose21 Programmer Jul 4, 2003 2,198 GB ld 22 REQ prt TYPE cequ you will see all the settings for the loops Upvote 0 Downvote