Need Windows 98 Drivers for Posiflex Jiva TP5815

[DaveH55]

I'm trying to replace one of my TPS 5700/5800 Posilex terminals with a TP 5815.
I can restore an image from the old system onto the new system but I am having trouble with the display driver. Everything will work fine for a while using a low resolution but every time I try to change the resolution it starts crashing with a fatal execption error and then when I boot it tells me the resolution is wrong and will not let me change it back to where it just was.

I have the drivers for the old system but they must be different between these 2 models.
Would anyone know where I can possibly get the display driver for a 5815 using windows 98?

Thank you for any help you can give me.
Dave

 

[DaveH55]

Thanks everyone but I fianally found a driver and everything is working now.

I wasted most of the day thinking it may not be the driver because I had a 5800 motherboard and when I replaced the board on the broken system my image booted up just fine. The only re-detection was for a new printer port. That caused me to think it wasn't a driver problem because I did not think there would be much of a difference between a TP5800 and a TP5815.

But finally I found an updated driver and that was all I needed for the 5815.
Thank you very much.
Dave