Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Need to know the command for configuring DLCI in a Cisco 1000 Series.
- Thread starter tjamm
- Start date
frame-relay interface-Dlci ( # ) IETF
IETF on the end if it is hooked up to
a none cisco device. For more info go to
and search for frame relay.
Good Luck !!! Jeter@LasVegas.com The best answer I could ever give is the one to maintain my Sanity
IETF on the end if it is hooked up to
a none cisco device. For more info go to
and search for frame relay.
Good Luck !!! Jeter@LasVegas.com The best answer I could ever give is the one to maintain my Sanity
Shouldn't need the IETF on a DLCI statement.
On the physical interface, you put "encapsulation frame-relay IETF" for non-Cisco encapsulation.
On the logical (or sub) interface, you put "frame-relay interface-dlci XX" to specify the PVC attached to that interface.
--chris
On the physical interface, you put "encapsulation frame-relay IETF" for non-Cisco encapsulation.
On the logical (or sub) interface, you put "frame-relay interface-dlci XX" to specify the PVC attached to that interface.
--chris
- Status