Need to add DECT without OTM

[Madil]

Hello all,
Is there any way to create a DECT Set through CLI through the DMC card. My client lose the OTM dongle. I can create the dect on the switch through the OVL but where i can get the authentification/PIN code?
Thanks

 

[Firebird Scrambler]

As far as I know, It's not possible. Your best bet is to get hold of another dongle, either the older Printer port one or the later USB one.

If you have the original dongle's ID and keycodes, then it's possible to change the ID of the replacement dongle if that one doesn't have the DECT feature enabled.

All the best

Firebird Scrambler
Meridian Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[Madil]

thank you. I have the TM keycode sheet where the DECT feature is 'ok' and the dongle type is USB. As we are not Nortel partner, I'm waitting the quotation.

 

[Sennback]

Remember, should you use the MAT/OTM/TM whatever its called, only for dect you can have a very old version. It supports dect anyway.