Need Option CFG for Networking to a MICS 6.1 with MCDN. PLZ

[viper222]

I am networking an Option 81 to a MICS 6.1 to have CLID Name and Number. I have the PRI and Norstar Advanced Private Networkingenabler codes installed on the MICS. I have the PRI T-1 built on the Option along with my CDP to route the calls but I am not sure how to configure the RDB and Trunks for this. As for the MICS I believe the it should be programmed as PRI / NI-2 / TIE / and then the appropriad DNIS and Route configuration. Any help, even just a hint, is very very greatly appreciated.

 

[luv2ski]

does this help


Meridian Customer Defined Network Requirements
MICS 5.0 will deliver advanced networking between the Norstar and the
Meridian 1 over dedicated point-to-point PRI spans using the MCDN protocol
to enable:
* Centralized voice mail and Attendant (Meridian Mail/Call Pilot) -
allowing a single voice mail system deployed at the network hub Meridian 1
to serve multiple sites, providing economies of scale and access to the same
voice messaging capabilities as users at the hub site.
*MCDN Features:
* Private Numbering Plan
* Network Message Waiting Indication
* Network Call Redirection Information
* Trunk Route Optimization.
* Private Network Tandem Calling.
To plan for the MCDN network the following requirements must be met on the
Meridian 1 PBX as well as the Meridian Mail or Call Pilot.
Meridian 1 Software Requirements
X11 Rls 21 to Rls 24.24 and Rls 25.30 software or above (Enterprise Feature
Set)
* End-to-End Signaling (Option 10)
* Message Center (Option 46)-IVMS Link (Option 35)
* Meridian Mail Link (Option 77, 85)
* Basic ACD features (Options 40, 45, 83)
* ISDN Primary Rate Interface or ISDN Signaling Link (Option 145/146
or 145/147) and associated prerequisites
* Advanced ISDN Features (Option 148)
* Network Message Services (Option 175)
For a new Meridian 1 (Option 81C, 61C or 51C) on X11 Rel. 25, the following
software packages should be ordered (in addition to the base software):
* SW0059B
* SW0052D
* SW0221C
* SW0051B
These packages will provide the required features listed above.
For a new Meridian 1 Option 11C or 11C Mini on X11 Rel. 25, either the
Enterprise software package or NAS/VNS software package should be ordered.
Meridian Mail Software Compatibility
* Rel. 7 (MM7) or above - currently shipping MM13.
Call Pilot Software Compatibility
* All
For a description of the features listed, please refer to the M1 NTP's or
contact CTAS at 1 800 4NORTEL.


ONLY 17 WEEKS TILL SKI SEASON STARTS

 

[viper222]

I just verified that I do have these software packages. Thank you. I guess I just don't have the NTP on how to program the Routes or trunks. Thanks for the help so far.