Need help with remove 1 PRI T1 circut from Opt 81c 1

[vietharry]

Hi All,

I am requesting LD carrier to shut down 1 PRI T1 circut this week
can you please show me how to disable 1 PRI T1 circuit from Opt 81c PBX? (loop 3)

Thanks,
Harry

 

[MossEng]

To Disable PRI cct on loop 3

LD 60 - STAT 3
This will give you Channel Information including D-Channel

LD 96 - DIS DCH <D-Channel No:>

LD 60 - DISL 3

 

[vietharry]

Thanks MossEng

 

[telecomPA]

when you're ready to out it completely, go to LD 20, print the TN for 3-1, then make a note of the route number and member.

go to LD 16, out the members, then go to LD 21, out the Route.

 

[vietharry]

Hi tellecomPA,

Can you please explain more in detail as what to do?
This is what I printed out TN 3-1 in LD 20 which is member and which is route?

REQ: PRT
TYPE: TN

TN 3 1
DATE
PAGE
DES

DES SPRINT_LD
TN 003 01
TYPE DID
CDEN SD
CUST 0
TRK PRI
PDCA 1
PCML MU
NCOS 7
RTMB 2 1
B-CHANNEL SIGNALING
NITE
STRI/STRO OWK OWK
AST NO
IAPG 0
CLS UNR DTN WTA LPR APN THFD HKD
P10 VNL
TKID
AACR NO
DATE 30 OCT 2006

Thanks,
Harry

 

[tnphoneman]

ld 14
out xx xx= the number of channels on the T1(if you go over it will take out channels from the next T1
type = did
tn = 3 1
enter all the way through.

ld 17
chg
adan
out dch x x= the dchannel you already disabled

ld 17
chg
cequ
enter until you get to the dlop prompt
dlop = x3


Signature===========================================
Artificial Intelligence Is No Match for Natural Stupidity.

The latest survey shows that 3 out of 4 people make up 75% of the population.

The original point and click interface was a Smith & Wesson.

Red meat is not bad for you, it is the green fuzzy meat that is bad.

 

[marcuspb]

Why not leave all of the programming and hardware alone?

That way if you ever need to add another PRI everything is there.