need help on where to punch down speakers to a MICS 8x24

[jsunn20]

I need some info on where to punch down the speaker wires to the 66 block for the paging on a 8x24 MICS.

 

[byrontel]

On the external lines connector...page out tip/ring violet orange. page relay make break yellow slate.
You will need an amplifier or control unit for external paging....you cannot connect speakers directly to 8x24.the paging output from ksu is 775mv accross impedance of 600 ohms.

 

[jerryreeve]

faq799-1780


----------------------------
JerryReeve
Communications Systems Int'l
com-sys.com

 

[jsunn20]

Thanks for the feedback.
I do have an amp an everything should be configured, well it was config for five speakers an 4 horn the new office they will only be using 3 speakers an I didnt know where to hook the speaker wires to. So i do not punch the speakers wres down to a block they are attached to the amp.

 

[senk1s]

the speaker goes to the amplifier

 

[bkrike]

If you have an amp then the speakers would terminate according to the amp's instructions. The MICS would only be providing the input source, which would also be connected to the amp. If you are unfamiliar with how to make the connections you should call your vendor.

 

[jsunn20]

Thanks for getting back to me guys.
Iam familar working with differ connections havent really mess around wit this type of system bfore, but it's no biggie i pickup on things quick thats how i got to where im @ now, but thanks alot guys ur info was helpful got the pa sys up an working..