Need Default IP address to program a BCM 100

[RoeKoe101]

I am trying to program a BCM 100 from a PC. I connot find the installer manuals and I need to know the default IP addresses to get onto the network inferface? Thanks

 

[endlesswinter]

No such thing as BCM 100.

 

[acewarlock]

Did you mean a BCM 1000?


10.10.10.1
10.10.13.1

But these are only good if they haven't been change.

 

[RoeKoe101]

Yes I did mean the BCM 1000. Sorry I forgot my zero. I will try both of those thank you. If is has been changed is there a way to figute it out or default? Thank you.

 

[acewarlock]

You could use the serial port and hyperterm, then 2 for conf and then Q to see how it set. You will need the Passwords to get in. do you know what Ver of software it has?

 

[RoeKoe101]

I personally have never installed a BCM or brought it up, but I have programmed them once initialized through both the network interface and the phone. This system was purchased on ebay with no provided documentation. I have not attempted to get into programming. I have the programming documentation from previous installs but I don't have the hardware installation documentation. With all that being said would the software version be on the cabinet somewere?

 

[scanner40]

Try these address
10.10.10.1 Lan 1
10.10.11.1 Lan 2

 

[acewarlock]

No