Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Need Default IP address to program a BCM 100

Status
Not open for further replies.

RoeKoe101

Vendor
Mar 16, 2006
9
US
I am trying to program a BCM 100 from a PC. I connot find the installer manuals and I need to know the default IP addresses to get onto the network inferface? Thanks
 
Did you mean a BCM 1000?


10.10.10.1
10.10.13.1

But these are only good if they haven't been change.
 
Yes I did mean the BCM 1000. Sorry I forgot my zero. I will try both of those thank you. If is has been changed is there a way to figute it out or default? Thank you.
 
You could use the serial port and hyperterm, then 2 for conf and then Q to see how it set. You will need the Passwords to get in. do you know what Ver of software it has?
 
I personally have never installed a BCM or brought it up, but I have programmed them once initialized through both the network interface and the phone. This system was purchased on ebay with no provided documentation. I have not attempted to get into programming. I have the programming documentation from previous installs but I don't have the hardware installation documentation. With all that being said would the software version be on the cabinet somewere?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top