I already have a t1 serial 0 interface setup.
My second, serial 1 interface is not setup, and I want
to configure a Point-to-Point link between two Routers.
I'm not sure if all i have to type in the command line is on both sides of the router is:
RouterA:
-config t
int s1
ip unnumbered
ip add 192.168.0.1 255.255.255.255(PPP does not need a public ip)
RouterB:
-config t
int s1
ip unnumbered
ip add 192.168.0.2 255.255.255.255
Thanks for your help.
My second, serial 1 interface is not setup, and I want
to configure a Point-to-Point link between two Routers.
I'm not sure if all i have to type in the command line is on both sides of the router is:
RouterA:
-config t
int s1
ip unnumbered
ip add 192.168.0.1 255.255.255.255(PPP does not need a public ip)
RouterB:
-config t
int s1
ip unnumbered
ip add 192.168.0.2 255.255.255.255
Thanks for your help.