Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
nec sv9100
- Thread starter Agitel
- Start date
Yes, but you will need new licenses and the migration license. I am attaching a manual that describes the process and what is needed to do the migration.
- Thread starter
- #3
Those documents in a nutshell.
Submit SKC to NEC for migration, they will ask you to generate the Feature Activation License and System Data reports. So I tend to give everything in one hit.
Download Database in 8100 PC Pro, Save, Open in 9100 PC Pro, this will migrate all your data. Ensure your 84-26, 10-12, and other vital programming is still present, this has dropped off on me previously, then you can remove all cards from chassis, leave extension and trunk boards hanging out the system, just disconnected from back plane, load the CP20 SV9100 card into the first slot where your CP-00 8100 CPU was. and power up system/initialize the card. Once its loaded, load your licensing from NEC, then Load your Database you saved previously.
Install 1 card at a time. When you first plug in card it will blink red, give it a few minutes and this will change to green blinking, this is the cards doing firmware updates, soon as all cards are in, your migration should be complete.
Submit SKC to NEC for migration, they will ask you to generate the Feature Activation License and System Data reports. So I tend to give everything in one hit.
Download Database in 8100 PC Pro, Save, Open in 9100 PC Pro, this will migrate all your data. Ensure your 84-26, 10-12, and other vital programming is still present, this has dropped off on me previously, then you can remove all cards from chassis, leave extension and trunk boards hanging out the system, just disconnected from back plane, load the CP20 SV9100 card into the first slot where your CP-00 8100 CPU was. and power up system/initialize the card. Once its loaded, load your licensing from NEC, then Load your Database you saved previously.
Install 1 card at a time. When you first plug in card it will blink red, give it a few minutes and this will change to green blinking, this is the cards doing firmware updates, soon as all cards are in, your migration should be complete.
- Thread starter
- #5