Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

NEC SV8100 Operator issue

Status
Not open for further replies.

Thomas VIII

Programmer
Jun 18, 2018
26
US
I have a SV8100 where the auto attendant picks up and the user presses 0 but the call is not going to the operator ext 321. 47-13 is defined as Unscreened transfer to 321 on 0.
One odd thing, if a caller presses 4 it comes back as I did not recogonize that command, then plays the greeting again and then you can press 0 it will go the defined operator.
Any suggestions?
 
Make sure the dial action table is assigned to the correct call routing mailbox in form 47-08
 
47-08 is not being used that I know of. Is there config options for mailbox 1? This is the one I presume is being used.
 
By default dial action table 1 is assigned to routing mailbox 1 in 47-08
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top