duongdvvpc
Technical User
NEC SV8100 connected to CO trunk with Trunk access code is 9. When dialing out it waits for so long and it takes about 10-15 seconds.
How to repair? Thank all.
How to repair? Thank all.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
NEC SV8100 DELAY
- Thread starter duongdvvpc
- Start date
- Status
belevedere
Instructor
Dial a # after the last digit. It should go out. You can set up ARS also which will dial out faster as well.
Salmanshahzad
IS-IT--Management
Hi
My Pbx is NEC IP2AP-924M We have 4 PBX hypo linse on one main number with called id. Rite now we have standard NEC IP2AP-6TXD TEL2 handset which does not show the incoming call # information; how to configure so it shows the incoming call information on handsets.
Regards
Salman
My Pbx is NEC IP2AP-924M We have 4 PBX hypo linse on one main number with called id. Rite now we have standard NEC IP2AP-6TXD TEL2 handset which does not show the incoming call # information; how to configure so it shows the incoming call information on handsets.
Regards
Salman
- Status
Similar threads