Wendelspanswick
Programmer
Hi,
We have a problem with DDI routing to a Department Group which occurred recently, user complained that no calls were coming through on the DDI, I tried talking her through various things and in the end to temporarily resolve the matter I dialed in and pointed the DDI direct to her extension.
I made a site visit and it's got me stumped...
2 extensions (715 which is a DT330 and 551 which is a POTS phone) are in Department Group index 005 which has a pilot number of 401, ring 401 and both extensions ring so they are both logged in.
If I change DDI Routing Target 1 to 401 and dial the DDI I get the engaged tone.
I've cancelled DG Transfer, DG DND and DG Delayed Transfer.
I've cleared all the relevant programming and remade it up using different DG index and pilot but still no joy.
I've done a Blade Reset on upload but nothing seems to resolve it and I'm stumped.
As a temporary measure I've pointed the DDI at 715 in Target 1 then created a IRG as Target 2 which contains both 715 and 551, Target 1 overflows to Target 2 on Busy/No Answer.
Software was updated to latest version 9.66 about 3 months ago.
Have you tried turning it off then on again!
We have a problem with DDI routing to a Department Group which occurred recently, user complained that no calls were coming through on the DDI, I tried talking her through various things and in the end to temporarily resolve the matter I dialed in and pointed the DDI direct to her extension.
I made a site visit and it's got me stumped...
2 extensions (715 which is a DT330 and 551 which is a POTS phone) are in Department Group index 005 which has a pilot number of 401, ring 401 and both extensions ring so they are both logged in.
If I change DDI Routing Target 1 to 401 and dial the DDI I get the engaged tone.
I've cancelled DG Transfer, DG DND and DG Delayed Transfer.
I've cleared all the relevant programming and remade it up using different DG index and pilot but still no joy.
I've done a Blade Reset on upload but nothing seems to resolve it and I'm stumped.
As a temporary measure I've pointed the DDI at 715 in Target 1 then created a IRG as Target 2 which contains both 715 and 551, Target 1 overflows to Target 2 on Busy/No Answer.
Software was updated to latest version 9.66 about 3 months ago.
Have you tried turning it off then on again!