NEC IPK II DTI card

[MrComputerTelephony]

Hello everyone,we recently adopted a customer that has a IPK II. What version software on the CPU II will support a PRI on the DTI Card? Thanks for the info.

 

[belevedere]

Enhancements: Version 1500 or higher:
 The T1/PRI Interface ETU can be programmed as a 4/8/12/16/20/24-port Fractional T1/PRI (when PRG
10-39-01 is Enabled).
 Supports Called Party Number Enhancement so the IPK II can edit the Called Party Number Parameter
using the Network Specified Parameter Table settings (PRG 26-12-01 and PRG 26-12-02).
Earlier versions worked, but you did not have the options listed above.
You should have v 1.61 or 2.11 loaded. Those were the last versions before giving way to the SV8100. V 2.11 required a license and gave you IP features.

 

[MrComputerTelephony]

Thanks belvedere for the info. Would the same CPU II software level be the same for a PRT card?

 

[belevedere]

The PRT card comes with PRI software already loaded. System v1.61, or licensed v2.11 will support the PRT card. Do not attempt to load v2.11 if you do not have the licensing to go along with it. Since it's EOL, it's not likely you can get any licenses. v.161 can be loaded over any earlier version 1.XX