Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

NEC Electra Professional CID

Status
Not open for further replies.
rupekish

rupekish

Technical User
Oct 4, 2002
9
CA
Hi,I would like to know the memory blocks for the CID programming on the NEC EPRO 11 ,and also the data to enter in those blocks. I found most of the memory blocks,but I am not sure what data to enter.

Regards
Roop Jag
 
Sort by date Sort by votes
There is probably too many commands to go through on this forum. If the EPRO is the same as the Australian Ranger pro then from memory the programming structure should be basically the same as the IPK. If this is the case then it would be best to get your hands on a copy of the Xen IPK MAT software and use the wizard feature.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Agitel
  • Question
nec sv9100
Replies
4
Views
408
Agitel
Agitel
R
  • Question
NEC IPK-I
Replies
1
Views
137
dmanghani
dmanghani
sparepart
  • Locked
  • Question
NEC Visio Stencils
Replies
0
Views
264
sparepart
sparepart
M
  • Locked
  • Question
NEC SV8100 firmware
Replies
5
Views
583
SV9100
SV9100
Saeidnec
  • Locked
  • Question
nec orginal firmawere
Replies
3
Views
364
DoubleDriveLine
DoubleDriveLine

Part and Inventory Search

Sponsor

Back
Top