NEC CISCO

[necvoipguy]

I have an NEC IMX hooked up to a 2851 cisco router via an NI2 PRI. Everything is working fine, however, the NEC seems to be stripping any calls from the 2851 router down to 4 digits... no matter how many digits are sent.

Any ideas how to change this?

 

[3racefan3]

Use ARTD - CDN 66 - to increase the number of digits to the correct number. Do this on the B-Channel route only.

 

[necvoipguy]

The only problem is that the internal dialing is 4 digit extensions.... wouldnt this have to stay at 4?

 

[necvoipguy]

I changed it to 12 and I can still call into the cisco equipment but when i place a call from the cisco IP phones everything rings busy now. When I had it set for 4 it worked both ways.