NAT on a Cisco 1605 Router

[mikevz]

I need to map a private ip address to a public ip address. I'm not sure where to get started. Do I telnet? Do I use Cisco Configmaker? When I use Cisco configmaker and try to detect the router it asks for username, unprivalidged password and privaliged password. I know the top password that I use to get in to the router via telnet, but what is the username and unprivaliged password.

Your help is greatly appreciated.

Thanks.

 

[jeter]

ip nat inside source static 192.168.1.1 206.159.12.5
this is the command that is required to point a private ip to a public ip address.

The gateway on a working pc to that router will give the ethernet ip address.
You can try to telnet, and or access the router through the console port.

If a username password is setup you may have to do a password recovery. Jeter@LasVegas.com
Fisher CCNA
Sprint-Data

 

[mikevz]

How do I do a password recovery?

 

[CiscoTech]

Look here-

http://www.cisco.com/warp/public/474/pswdrec_1600.shtml

Step by step instructions of how to do a Password Recovery.