NAT-ing Multiple Interfaces i.e. Frame Relay 0.1 0.2 0.3

[GLHEC]

I've got a question,,, is it possible to nat different pools on more than 1 interface? For instance can we use a different pool of address's on each different frame relay sub-interface? We want to do this because we have different rule sets on another firewall for the respective address spaces and need to keep them separated. I thought it might be possible through acl but I am not sure. If anyone could shoot me some advice or a tip it would be greatly appreciated.
glhec

 

[GLHEC]

Here's another,, do you have to have inside and outside configured on interfaces. For instance have only an outside configured on a serial and not an inside on t0 or e0. We have nat happening to the outside numbers turning them to privates. long story why.

 

[routerhead]

You can NAT different pools on seperate interfaces. You still only have a certain number of global addresses in which can be accessed. You can configure inside NAT to allow inside local host to access to global addresses from the NAT pool.

Hope I helped