I'm struggling to set up WinRoute Pro after having Blueyonder Broadband installed.
Host PC is XP Home SP1.
Internet & Email (IE6 & OE6) work OK.
WinRoute worked fine on XP using RAS via 56K modem.
NAT is set up, and no proxy setting at all.
DNS is enabled, but NOT specified in DHCP.
The 2 Client PCs are W98 (IE6 & OE6), set to automatically obtain IP addresses, and Gateway is specified as Host's IP address.
The behaviour is odd!...
1) Host PC can access POP3 & SMTP successfully
2) Clients can access SMTP but not POP3 - on the same ISP (in this case, Hotchilli) (ie: they can send but not receive!)
3) Clients can browse only a few sites ....eg: is OK, but cannot be accessed (yeah - for my kids! Honest!) In fact, most sites (inc Blueyonder's own site - my ISP) are not accessible. The progress bar pretends to move for a while, and the address shows in the info pane, and then "The page cannot be found" etc!
I've tried trawling through the manual and inserting the example settings.
NAT is enabled on the USB cable modem & not on the NIC
Subnets are different for Internal & Internet cards
Subnet masks are the same (though making them different did not solve the problem).
ICS & XP Firewall are NOT enabled at all.
Any suggestions?
Host PC is XP Home SP1.
Internet & Email (IE6 & OE6) work OK.
WinRoute worked fine on XP using RAS via 56K modem.
NAT is set up, and no proxy setting at all.
DNS is enabled, but NOT specified in DHCP.
The 2 Client PCs are W98 (IE6 & OE6), set to automatically obtain IP addresses, and Gateway is specified as Host's IP address.
The behaviour is odd!...
1) Host PC can access POP3 & SMTP successfully
2) Clients can access SMTP but not POP3 - on the same ISP (in this case, Hotchilli) (ie: they can send but not receive!)
3) Clients can browse only a few sites ....eg: is OK, but cannot be accessed (yeah - for my kids! Honest!) In fact, most sites (inc Blueyonder's own site - my ISP) are not accessible. The progress bar pretends to move for a while, and the address shows in the info pane, and then "The page cannot be found" etc!
I've tried trawling through the manual and inserting the example settings.
NAT is enabled on the USB cable modem & not on the NIC
Subnets are different for Internal & Internet cards
Subnet masks are the same (though making them different did not solve the problem).
ICS & XP Firewall are NOT enabled at all.
Any suggestions?