Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
NAM w/ Fiber
- Thread starter RYLSFAN
- Start date
powerflower
Vendor
F985 will give you main DN. they will then be sequential based on number of ports.
In System programing you will find them under MAINTENANCE they will be ports X01, X02, X03 etc. X being the module port the the fibre is plugged into.
Of course the NAM must be working at the time you check
M
In System programing you will find them under MAINTENANCE they will be ports X01, X02, X03 etc. X being the module port the the fibre is plugged into.
Of course the NAM must be working at the time you check
M
- Thread starter
- #3
If you know what expansion port you're going to use you can just look in Maintnance programming and check the 1st port of that expansion port and see the dn number there.
(ie. expansion port 3, the ports you'd want to look at are 301 then 302 and 304 and so on depending on how many ports your NAM is)
Louie Roldan
(ie. expansion port 3, the ports you'd want to look at are 301 then 302 and 304 and so on depending on how many ports your NAM is)
Louie Roldan
- Status
