MX-ONE and Asterisk

[fabioolima]

Hello there !!

I'm trying to integrate MX-One and Asterisk, and so far I'm doing pretty good , I can make call from Asterisk to MxOne and the other way around.

But I'm getting the problem that when I make a call from MxOne to Asterisk, the B-number do not show the ID Name <number>, it only shows the number !! And in some particular case it show Public on the display.
I was trying to work with SIP Headers, but it's a little bit hard to find any information about MXONE headers ... :S

My sip_route configuration :
My Invite URI string 0 = sip:?@[asterisk IP]
My From URI string 0 = sip:?@[asterisk IP]

Thanks a lot !!

Best Regards !!

Fabio Lima

 

[lindelott]

Let it try:
My From URI string 0 = sip:?@[ESU IP]

 

[HD1960]

Hello
What is the configuration of the road sip, Roddi,rocai and rodai

Best Regards !!

 

[fabioolima]

Hello HD1960 !!!

Just some more info, my MXONE has the dialplan as 9XXX and my asterisk has the dialplan 6XXX.

My RODAP for this SIP route :

ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
51 7110000000000010 4 31100000001 0 30 128 03151515 0111110000A0 000100

My RODDP for this SIP route :

EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
6 51 170700000000025010700110100 0 1 0


My RODAP for this SIP route :

ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
51 TL66 H'00001000 H'00000000 H'00000900 NO


Thank you advanced !!!

Best regards.

 

[aau2]

Hi, try to change sig of route to 0111110000A1, and adc to 17071000000025010700110100

 

[rfpup]

Let suppose than calling from extension A of MX-one to ext B of another PBX connected through SIP trunking. Will the name of extension A be displayed in extension B and vice versa?

 

[HD1960]

Hello

Merci beaucoup,Thank you

Best regards.