MWI remote node don´t work

[IpofficeBoy]

I´ve a 8700 CM 2.2 and supplementary service protocol=b.
in trunk group (to 8500), with a MM3.0 (H.323 connected) working fine, MWI,find-me..etc..
I´ve a 8500 CM 2.2 with H.323 to 8700 and supplementary service protocol=b in trunk group to 8700.
The voice system MM3.0 is working ok with 8500 (find-me,call-me) but the MWI don´t work.
I´ve NCA TSC Channel channel (dcs and Qsig-mwi)permanent and up in the signaling group (8500 and 8700).
In the log OHV I´ve the nex message:
swe\n30\n51999\nStation is invalid\n´.The 51999 is the remote station.
Thanks.

 

[KenMeans]

Can you manually turn the light on 51999 from the 8500?

Ken Means

http://www.tel-is.com

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)

 

[IpofficeBoy]

Hi:
When i change in the station second page,LWC Reception to SPe, and i call to this station from 8700 o 8500 and i push the key leave a message, the light is on.
When a change to NONE and MWI server to qsig-mwi, i can´t manually turn the light on .

Thank.

 

[KenMeans]

Are you sure the S8500 is set up for QSIG? It may not have the features turned on

Ken Means

http://www.tel-is.com

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)

 

[IpofficeBoy]

Hi:

The trunk configuration is:

Group Number: 7 Group Type: isdn CDR Reports: y
Group Name: Iptrunk Gesta COR: 65
TN: 1 TAC: #07
Direction: two-way Outgoing Display? n Carrier Medium: IP
Dial Access? y Busy Threshold: 99 Night Service:
Queue Length: 0
Service Type: tie Auth Code? n TestCall ITC: unre
Far End Test Line No:
TestCall BCC: 4
TRUNK PARAMETERS
Codeset to Send Display: 6
Codeset to Send National IEs: 6
Max Message Size to Send: 260
Charge Advice: none
Supplementary Service Protocol: b
Digit Handling (in/out): enbloc/enbloc

Trunk Hunt: cyclical
QSIG Value-Added? n

Digital Loss Group: 13
Incoming Calling Number - Delete: Insert: Format:
Bit Rate: 1200
Synchronization: async Duplex: full
Disconnect Supervision - In? y Out? y

Answer Supervision Timeout:
0

And the sig is:
SIGNALING GROUP

Group Number: 7 Group Type: h.323
Remote Office? n
Max number of NCA TSC: 16
SBS? n
Max number of CA TSC: 31

Trunk Group for NCA TSC: 7
Trunk Group for Channel Selection: 7
Supplementary Service Protocol: a
T303 Timer(sec): 10
1: 51804 y permanent 51789 dcs 2: 51805 y permanent 51788 audix


Thanks