MWI not turning on with Messaging R2.5

[ScoTTeL2]

I am sure the problem with no MWI is that I have not enabled the ports for rotary dialing. I cannot seem to find where to do this. Any ideas? I am not new to Legend by any means, but have never had to enable rotary dialing and cannot find it anywhere.

 

[TouchToneTommy]

It's under Extensions, assuming that you have a Release 7. If it is earlier, you don't have Rotary Enable, and cannot use Merlin Messaging.

 

[tdaugirdas]

Press Menu, system program, start, extentions, more, more, rotary enable - keyin each vm ext port# and press enter - then press Inspect to make sure all are there. Then exit out.

Tom Daugirdas,
President
STCG, Inc.
stcg.com

 

[ScoTTeL2]

Okay, there is my problem. The processor is a r6.1
I have the upgrade to take to 7 or magix1.0 or 2.0.
Will have to upgrade.
Thanks guys!

 

[tdaugirdas]

Don't forget to do a backup of the programming to WinSPM - and then "convert" that file to whatever software you plan to upgrade the processor to. The restore will have to be done from WinSPM - using the converted backup data file.

Tom Daugirdas,
President
STCG, Inc.
stcg.com

 

[Telecomboy]

And if you upgrade to magix, no ATL modules can be used.